Supero C7B360-CB-ML, User Manual

Page: 84 / 113

Chapter 4: AMI BIOS
4-19
Console Redirection
Select Enabled to use a COM port selected by the user for EMS Console
Redirection. The options are
Disabled (unchecked) or Enabled (checked) .
*If the item above set to Enabled, the following features will become
available for user configuration:

Console Redirection Settings
Out-of-Band Mgmt Port
The feature selects a serial port in a client server to be used by the
Windows Emergency Management Services (EMS) to communicate
with a remote host server. The options are
dependent on the avail-
able COM ports .
Terminal Type
Use this feature to select the target terminal emulation type for Con-
sole Redirection. Select VT100 to use the ASCII character set. Select
VT100+ to add color and function key support. Select ANSI to use the
extended ASCII character set. Select VT-UTF8 to use UTF8 encoding
to map Unicode characters into one or more bytes. The options are
ANSI, VT100, VT100+, and
VT-UTF8 .
Bits per second
This feature sets the transmission speed for a serial port used in Con-
sole Redirection. Make sure that the same speed is used in both host
computer and the client computer. A lower transmission speed may
be required for long and busy lines. The options are 9600, 19200,
57600, and
115200 (bits per second).
Flow Control
Use this feature to set the flow control for Console Redirection to pre -
vent data loss caused by buffer overflow. Send a "Stop" signal to stop
data sending when the receiving buffer is full. Send a "Start" signal
to start data sending when the receiving buffer is empty. The options
are
None, Hardware RTS/CTS, and Software Xon/Xoff.
The setting for each these features is displayed:
Data Bits
Parity
Stop Bits