Supero 7042M-6, User Manual

Page: 39 / 106

Chapter 5: Advanced Motherboard Setup
5-5
5-3 Connecting Cables
Now that the processors and heatsinks are installed, the next step is to
install memory and connect the cables to the motherboard. These include
the data (ribbon) cables for the peripherals and control panel and the power
cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have
been carefully routed in preconfigured systems to prevent them from block-
ing the flow of cooling air that moves through the system from front to back.
If you need to disconnect any of these cables, you should take care to keep
them routed as they were originally after reconnecting them (make sure the
red wires connect to the pin 1 locations). If you are configuring the system
yourself, keep the airflow in mind when routing the cables. The following
data cables (with their motherboard connector locations noted) should be
connected. See the motherboard layout figure in this chapter for connector
locations. See Section 5-8 for data cable pin definitions.
l
IDE Device Cables (IDE#1 and IDE#2)
l
Floppy Drive Cable (JP7)
l
Ultra 160 LVD SCSI Cables (JA1 and JA2)
l
Control Panel Cable (JF2, see next page)
Connecting Power Cables
The P4DMS-6GM has a 24-pin primary power supply connector desig-
nated "ATX Power" for connection to the ATX power supply. The ATX
power connector is also keyed to accept 20-pin power connectors if the
power supply you are using has that type. See Section 5-8 for power
connector pin definitions.