Supero 5037MR, User Manual

Page: 67 / 106

Chapter 6: Advanced Chassis Setup
6-11
6-6 Removing and Installing Motherboard Nodes
Figure 6-10. Removing Nodes from the System
Release Tab
Node Power LED
Node Power Button
Node Handle
The SC938H chassis comes equipped with eight removable nodes, each one con-
taining an individual motherboard. Removing these nodes will also power-down the
corresponding hard drives. See the table in Section 6-3 to determine which hard
drives are controlled by each node.
Removing Nodes from the System
1. Power-down the individual node by pressing that node's power button.
2. Press and hold down the release tab on the back of the node.
3. Using the node's handle, pull the node from the chassis.
Warning: Except for short periods of time while swapping nodes, do not
operate the server with the node bays empty. In the unlikely event of a
node failure, remove the failed node and replace it with the dummy node
that was included with the system..
!