Supero 2027R-N3RF4+, User Manual

Page: 43 / 110

Chapter 5: Advanced Serverboard Setup
5-11
Riser Card Support
Riser Card Expansion Card Supported
RSC-R2UW-2E8R 2x low-profile PCI-E x8 cards
RSC-R2UW-2E16-2E8 2x standard PCI-E x16 cards, 2x standard PCI-E x8 cards
PCI Card Locations
# Expansion Card # Expansion Card
1 PCI-E 3.0 x8: Low-profile (2.536"), 6.6" length 4 PCI-E 3.0 x8: Full Height (4.2"), 16.5" length
2 PCI-E 3.0 x8: Low-profile (2.536"), 6.6" length 5 PCI-E 3.0 x16: Full Height (4.2"), 10" length
3 PCI-E 3.0 x16: Full Height (4.2"), 16.5" length 6 PCI-E 3.0 x8: Full Height (4.2"), 6.6" length
5-6 Adding PCI Cards
PCI Expansion Slots
Riser cards installed to the system allow you to add PCI expansion cards (see
below). The 2027R-N3RF4+/2027R-N3RFT+ can support the use of two standard
size (full-height), two low-profile and two full-height, half-length expansion cards
(with pre-installed riser cards).
PCI Card Installation
Before installing a PCI add-on card, make sure you power off the system first. Begin
by removing the top chassis cover. Two riser cards should be pre-installed into the
system. Remove the screws that secure the riser cards to the rear of the chassis
then lift the riser card assembly from the chassis. Insert the PCI card into the riser
card slot, pushing down with your thumbs evenly on both sides of the card - note
that the add-on card attaches to the riser card with a single screw.
After the card has been installed, reinsert the riser card back into the expansion slot
on the board, then secure it with the same screws you removed previously. Finish
by replacing the chassis cover.
1 3
4
6
5
2