Supero 1027R-WRF4+, User Manual

Page: 10 / 108

1-2
S
UPER
S
ERVER 1027R-WRFT+/1027R-WRF4+ User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 1027R-WRFT+/1027R-WRF4+ lies the X9DRW-
3TF+/X9DRW-3LN4F+, a dual processor serverboard based on the Intel® C606
chipset. Below are the main features of the serverboard. (See Figure 1-1 for a
block diagram of the chipset).
Processors
The X9DRW-3TF+/X9DRW-3LN4F+ supports single or dual Intel® E5-2600 Series
(Socket R) processors in LGA 2011 sockets. Please refer to our web site for a
complete listing of supported processors (www.supermicro.com).
Memory
The X9DRW-3TF+/X9DRW-3LN4F+ features 24 DIMM slots that can support up
to 768 GB of registered/unbuffered ECC DDR3-1600/1333/1066/800 SDRAM or
LRDIMM type memory. Please refer to Chapter 5 for installing memory.
Onboard SAS
A SAS controller is integrated into the chipset to support eight SAS 2.0 ports. The
hot-swap SAS drives are connected to a backplane that provides power, bus ter-
mination and configuration settings.
Note: RAID 0, 1, 5, 6, 10, 50 and 60 is supported. Refer to the following ftp site
for setup guidelines:
<ftp://ftp.supermicro.com/driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf>.
Onboard Serial ATA
An on-chip SATA controller is integrated into the X9DRW-3TF+/X9DRW-3LN4F+ to
provide a six-port, SATA subsystem (two SATA 3.0 ports and four SATA 2.0 ports),
which is RAID 0, 1, 5 and 10 supported (RAID 5 is supported with Windows OS
only). The SATA drives are hot-swappable units.
Note:
You must have RAID set up to enable the hot-swap capability of the SATA
drives. Documentation on RAID setup guidelines can be found on our web site.
Rear I/O Ports
The color-coded I/O ports include one COM port, a VGA (monitor) port, two USB
2.0 ports, PS/2 mouse and keyboard ports and one dedicated IPMI LAN port. In
addition, the X9DRW-3TF+ has two 1 Gb LAN (Ethernet) ports and two 10 Gb LAN
ports and the X9DRW-3LN4F+ has four 1 Gb LAN ports.