4
Distance of 10ft
Distance of 10ft
Distance of 10ft
Distance of 8ft
Distance of 10ft
Battery Charging Instructions
2
1. Before charging, the drone should be stopped for 10-15 minutes to ensure the built-in Li-Po
battery has cooled completely.
2 .Before continuing flight, the drone should be stopped for 10-15 minutes to ensure the built-in
motors have cooled completely.
Notes:
Environment for flight
If you turn on controller and push
the throttle up then down and the
transmitters LED blinks on/off,
you need to change the batteries.
1. Fly on a clear sunny day without wind.
Do not fly in extreme temperatures. Do not fly in temperatures above 113 degrees Fahrenheit (45 Degrees Celsius) or
below 50 degrees Fahrenheit (10 degrees Celsius). Flying in extreme weather will effect performance and may damage
product. Do not fly in windy conditions, wind will limit and disturb flying control. In very windy conditions your drone
may become lost and/or damaged.
2. Select large, wide open areas for flying, make sure there are no people, animals, or objects nearby.
1.
SD Card Installation:
Insert the SD card into the slot, lightly press until the SD card clicks into place. Press
the SD card to eject card.
Note:
The camera indicator will not light up if the SD card is not inserted properly.
2.
Camera Light:
[Green – Standby status] [Red Light Flashes Continuously – Start to record]
[Red Light Stops Flashing – Quit recording]
3.
Recording Function:
Turn on the drone, press the Camera Button to start recording. Press the Camera
Button again to quit the recording process and save the video onto the SD card.
4.
Video Operations:
Turn the quadcopter off. Remove the SD card, then install it into a card reader (connected
to the computer). Video can be viewed using most media players.
Camera
Insert the SD card into the
recording unit.
Press the SD card lightly,
then remove the card.
Preparations of Video Recording
1. When flying the drone, please connect the drone’s
power with two wires (positive and negative pole) to the
battery with two wires (positive and negative pole).
(figure 1).
2. When charging, please unplug the two wires (positive
and negative pole) plug first, then connect the drone’s
three wire plug to the charger. (figure 2). Notice:
Charger Indicator LED lights up red while charging.
Once charging is complete, the Charger Indicator will
turn off.The charging time is about 150 mins. Run time
per charge is about 6 minutes.