2-28
X10DGQ Motherboard User’s Manual
IPMI CODE
BAR CODE
X10DGQ
Rev. 1.00
A. VGA Enable
B. BMC Enable
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA connector. The default
setting is on pins 1/2 to enable the con-
nection. See the table on the right for
jumper settings.
VGA Enable
Jumper Settings
Jumper Setting Definition
1-2
Enabled (Default)
2-3
Disabled
BMC Enable
Use Jumper JPB1 to enable the Base-
board Management Controller (BMC)
installed on the motherboard to provide
IPMI 2.0/KVM support. See the table on
the right for jumper settings.
BMC Enable
Jumper Settings
Jumper Setting Definition
Pins 1-2
BMC Enable (Default)
Pins 2-3
Disable (Do not use
this setting!)
A
B
Warning!
Jumper JPB1 (BMC Enable) is for engineering debugging use only. The
manufacturer's default setting is on pins 1-2 to enable the BMC. Disabling the BMC
will disable the server's onboard graphics controller, hardware monitoring, and system
health management.
