SuperWorkstation 5049A-TR User's Manual
104
Port 0 ~ Port 7 Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disable and
Enable
.
Port 0 ~ Port 7 Spin Up Device
On an edge detect from 0 to 1, set this feature to allow the PCH to initialize the device.
The options are
Disable
and Enable.
Port 0 ~ Port 7 SATA Device Type
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State drive or a Hard Disk Drive. The options are
Hard Disk Drive
and Solid State
Drive.
PCIe/PCI/PnP Configuration
The following information will display:
•
PCI Bus Driver Version
•
PCI Devices Common Settings:
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Disabled and
Enabled
.
SR-IOV Support
Use this feature to enable or disable Single Root I/O Virtualization Support. The options are
Disabled
and Enabled.
MMIO High Base
Use this feature to select the base memory size according to memory-address mapping for
the I/O hub. The options are
56T
, 40T, 24T, 16T, 4T, 2T, and 1T.
MMIO High Granularity Size
Use this feature to select the high memory size according to memory-address mapping for
the I/O hub. The options are 1G, 4G, 16G, 64G,
256G
, and 1024G.
Maximum Read Request
Use this feature to select the Maximum Read Request size of the PCI-Express device, or
select Auto to allow the System BIOS to determine the value. The options are
Auto
, 128
Bytes, 256 Bytes, 512 Bytes, 1024 Bytes, 2048 Bytes, and 4096 Bytes.
MMCFG Base
Use this feature to select the low base address for PCI-E adapters to increase base memory.
The options are 1G, 1.5G, 1.75G,
2G
, 2.25G, and 3G.
