SuperServer E102-9AP-L User's Manual
38
Wait For "F1" If Error
This feature forces the system to wait until the F1 key is pressed if an error occurs. The
options are
Disabled
and Enabled.
INT19 Capture Trap Response
Interrupt 19 is the software interrupt that handles the boot disk function. When this item is
set to Immediate, the ROM BIOS of the host adaptors will "capture" Interrupt 19 at bootup
immediately and allow the drives that are attached to these host adaptors to function as
bootable disks. If this item is set to Postponed, the ROM BIOS of the host adaptors will not
capture Interrupt 19 immediately and allow the drives attached to these adaptors to function
as bootable devices at bootup. The options are
Immediate
and Postponed.
Re-try Boot
If this feature is enabled, the BIOS will automatically reboot the system from a specified boot
device after its initial boot failure. The options are
Disabled
and EFI Boot.
Power Configuration
DeepSx Power Policies
Use this feature to configure the Advanced Configuration and Power Interface (ACPI) settings
for the system. Enable S5 to power off the whole system except the power supply unit (PSU)
and keep the power button alive so that the user can wake up the system by using a USB
keyboard or mouse. The options are
Disabled
and Enabled.
Watch Dog Function
If this feature is enabled, the Watch Dog timer will allow the system to reboot when it is inactive
for more than five minutes. The options are
Disabled
and Enabled.
Power Button Function
This feature controls how the system shuts down when the power button is pressed. Select 4
Seconds Override for the user to power off the system after pressing and holding the power
button for 4 seconds or longer. Select Instant Off to instantly power off the system as soon
as the user presses the power button. The options are
Instant Off
and
4 Seconds Override.
Restore on AC Power Loss
Use this feature to set the power state after a power outage. Select Power Off for the system
power to remain off after a power loss. Select Power On for the system power to be turned
on after a power loss. Select Last State to allow the system to resume its last power state
before a power loss. The options are Stay Off,
Power on
,
and
Last State
.
*This feature is not available when DeepSX Power Policies is Enabled.
