32
SuperServer E102-9AP-L User's Manual
Chapter 4
Software
After the hardware has been installed, you should install the Operating System (OS) and
install the drivers. Necessary drivers and utilities may be found at
https://www.supermicro.
com/wftp/driver
.
4.1 OS Installation
Installing Windows to a Non-RAID System
1. Insert Microsoft's Windows OS Setup DVD in a USB/SATA DVD device.
2.
Insert USB flash drive with RST/RSTe driver.
3. Boot from a bootable device with Windows OS installation.
Note
: Press the “F11” key when the system boots up to evoke the bootable devices list.
4. Reach the section of the installation procedure in which you select a drive to install
Windows. The disk you are using should be listed. If not,
•
Load the driver by clicking on the “Load driver” icon at bottom left corner.
•
Browse the USB folder for the proper driver files.
•
Choose the SATA/sSATA AHCI driver indicated in the Windows OS Setup screen, then
choose the hard drive in which you want to install it.
5.
Once all devices are specified, continue with the installation.
After the Windows OS installation is completed, the system will automatically reboot several
times.
