Supermicro SuperServer 6027TR-D70RF+, User Manual

Page: 133 / 138

A-1
Appendix A: BIOS Error Beep Codes
Appendix A
BIOS Error Beep Codes
During the POST (Power-On Self-Test) routines, which are performed each time
the system is powered on, errors may occur.
Non-fatal errors are those which, in most cases, allow the system to continue the
boot-up process. The error messages normally appear on the screen.
Fatal errors are those which will not allow the system to continue the boot-up
procedure. If a fatal error occurs, you should consult with your system manufacturer
for possible repairs.
These fatal errors are usually communicated through a series of audible beeps. The
numbers on the fatal error list (on the following page) correspond to the number
of beeps for the corresponding error. All errors listed, with the exception of Beep
Code 8, are fatal errors.
A-1 AMIBIOS Error Beep Codes
Beep Code Error Message Description
1 beep Refresh Circuits have been reset (Ready to power up)
5 short beeps and 1
long beep Memory error No memory detected in the system
5 long and 2 short
beeps Display memory
read/write error Video adapter missing or with faulty memory
5 beeps No Con-In or
NoCon-Out devices Con-In: USB or PS/2 keyboard,PCI or Serial Console
Redirection, IPMI KVM or SOL
Con-Out: Video Controller, PCIor Serial Console Redirection,
IPMI SOL
1 beep per device Refresh 1 beep for each USB device
X9 IPMI Error Codes
1 continuous beep System overheat System overheat