Supermicro SUPERSERVER 6022L-6, User Manual

Page: 23 / 112

Chapter 2: Server Installation
2-7
2-5 Checking the Motherboard Setup
After you install the 6022L-6 in the rack, you will need to open the unit to
make sure the motherboard is properly installed and all the connections
have been made.
1. Accessing the inside of the 6022L-6 (see Figure 2-5):
First, release the retention screws that secure the unit to the rack.
Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click"). Next, depress the two buttons on the top
of the chassis to release the top cover. There is a large rectangular
recess in the middle front of the top cover to help you push the cover
away from you until it stops. You can then lift the top cover from the
chassis to gain full access to the inside of the server.
2. Check the CPUs (processors):
You should have one or two processors already installed into the
system board. Each processor should have its own heatsink attached.
See Chapter 5 for instructions on processor installation.
3. Verify the proper CPU speed setting:
If the CPU speed is not automatically detected you will need to set the
correct speed with DIP Switch 4 on the motherboard. (Most Intel proces-
sors have a fixed Core/Bus ratio that overwrites the setting of DIP Switch
4
; you should not need to make any changes with DIP Switch 4
.)
4. Check the system memory:
Your 6022L-6 server system may have come with system memory al-
ready installed. Make sure all DIMMs are fully seated in their slots. For
details on adding system memory, refer to Chapter 5.
5. Installing PCI cards:
If desired, you can install up to three standard size PCI cards to the
system. See the appropriate section in Chapter 5 for details on installing
PCI add-on cards.