Supermicro SUPERSERVER 6021i, User Manual

Page: 60 / 110

6-2
S
UPER
S
ERVER
6021i
Manual
Figure 6-1. Chassis Front and Rear Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the motherboard to provide you with system
status indications. A ribbon cable has bundled these wires together to
simplify the connection. Connect the cable from JF1 on the motherboard
to JP4 on the Control Panel PCB (printed circuit board). Make sure the
red wire plugs into pin 1 on both JF1 and JP4. Pull all excess cabling out
of the airflow path. The LEDs inform you of system status. See
"Chapter 3: System Interface" for details on the LEDs and the control
panel buttons. Details on JF1 can be found in the "Chapter 5: Advanced
Motherboard Installation."
System Reset
Control Panel/
System LEDs
Main Power
Slim-Line
CD-ROM Drive
Floppy Drive
IDE Drives
CD-ROM Drive