Supermicro SUPERSERVER 6021i, User Manual

Page: 39 / 110

Chapter 5: Advanced Motherboard Setup
5-5
5-4 I/O Ports
The I/O ports are color coded in conformance with the PC99 specification.
See Figure 5-2 below for the colors and locations of the various I/O ports.
Parallel Port
(Burgundy)
COM1 COM2 Keyboard
(Purple)
Mouse
(Green)
USB
Ports
(Black)
Ethernet
Port
(Black)
(Turquoise)
5-5 Installing Processors
Avoid placing direct pressure to the top of the pro
cessor package. Always connect the power cord last
and always remove it before adding, removing or
changing any hardware components.
1. Installing the FCPGA processors:
The P3TDDE has two 370-pin sockets, which support single or dual Intel
Pentium
®
III FCPGA 500 MHz - 1.40 GHz processors and single or dual low
power Pentium
®
III processors at front bus speeds of 100 and 133 MHz. Lift
the lever on the FCPGA socket and insert the processor keeping the notched
corner oriented toward pin one on the socket. Make sure the processor is
fully seated in the socket and then close the lever. You can also install a
single processor on the motherboard without changing any jumper settings.
(See Figure 5-3 for views of a 370-pin FCPGA socket before and after
processor installation.)
!
Figure 5-2. P3TDDE Rear Panel I/O Ports