Supermicro SUPERSERVER 6021H, User Manual, Page: 62 / 112

6-2
SUPERSERVER 6021H Manual
Figure 6-1. Chassis Front and Rear Views
System Reset
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the motherboard to provide you with system status
indications. A ribbon cable has bundled these wires together to simplify the
connection. Connect the cable from JF1 on the motherboard to JP4 on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into
pin 1 on both JF1 and JP4. Pull all excess cabling out of the airflow path.
The LEDs inform you of system status. See Chapter 3: System Interface for
details on the LEDs and the control panel buttons. Details on JF1 can be
found in the Chapter 5: Advanced Motherboard Installation.
Control Panel/
System LEDs
Main Power
Slim-Line
CD-ROM Drive
Floppy Drive SCSI Drives
3 Full Length PCI Slots