Supermicro SUPERSERVER 6021H, User Manual, Page: 106 / 112

SUPERSERVER 6021H User's Manual
B-6
Checkpoint Code Description
66h Completed programming DMA controllers 1 and 2. Initializing the
8259 interrupt controller next.
67h Completed 8259 interrupt controller initialization.
7Fh Extended NMI source enabling is in progress.
80h The keyboard test has started. Clearing the output buffer and
checking for stuck keys. Issuing the keyboard reset command
next.
81h A keyboard reset error or stuck key was found. Issuing the
keyboard
controller interface test command next.
82h The keyboard controller interface test completed. Writing the
command byte and initializing the circular buffer next.
83h The command byte was written and global data initialization has
completed. Checking for a locked key next.
84h Locked key checking is over. Checking for a memory size
mismatch with CMOS RAM data next.
85h The memory size check is done. Displaying a soft error and
checking for a password or bypassing WINBIOS Setup next.
86h The password was checked. Performing any required program-
ming before WINBIOS Setup next.
87h The programming before WINBIOS Setup has completed.
Uncompressing the WINBIOS Setup code and executing the
AMIBIOS Setup or WINBIOS Setup utility next.
88h Returned from WINBIOS Setup and cleared the screen. Perform-
ing any necessary programming after WINBIOS Setup next.
89h The programming after WINBIOS Setup has completed. Displaying
the power on screen message next.
8Bh The first screen message has been displayed. The <WAIT...>
message is displayed. Performing the PS/2 mouse check and
extended BIOS data area allocation check next.
8Ch Programming the WINBIOS Setup options next.
8Dh The WINBIOS Setup options are programmed. Resetting the hard
disk controller next.
8Fh The hard disk controller has been reset. Configuring the floppy
drive controller next.
91h The floppy drive controller has been configured. Configuring the
hard disk drive controller next.
95h Initializing the bus option ROMs from C800 next. See the last page
of this chapter for additional information.
96h Initializing before passing control to the adaptor ROM at C800.
97h Initialization before the C800 adaptor ROM gains control has
completed. The adaptor ROM check is next.