Supermicro SUPERSERVER 6013P-i, User Manual

Page: 36 / 102

5-2
S
UPERSERVER 6013P-i User’s Manual
IMPORTANT: Always connect the power cord last and always remove it
before adding, removing or changing any hardware components. Make
sure that you install the processor into the CPU socket before you install
the heatsink. The X5DPR-iG2 can support either one or two Intel Xeon
processors of up to 3.06 GHz. If installing one processor only, install it into
CPU socket #1. (Pictures below show 603-pin CPU sockets.)
!
5-2 PGA Processor and Heatsink Installation
When handling the processor package, avoid placing direct
pressure on the label area of the fan. Also, do not place the
serverboard on a conductive surface, which can damage the
BIOS battery and prevent the system from booting up.
1. Lift the lever on the CPU socket.
Lift the lever completely or you will
damage the CPU socket when
power is applied. (Install a
processor into CPU #1 socket
first.)
Socket lever
2. Install the CPU in the socket.
Make sure that pin 1 of the CPU is
seated on pin 1 of the socket (both
corners are marked with a
triangle). When using only one
CPU, install it into CPU socket #1
(CPU socket #2 is automatically
disabled if only one CPU is used).
Pin 1
3. Press the lever down until you
hear it *click* into the locked
position. See Figure 5-1 for
pictures of the (604-pin) CPU
socket before and after the
processor is installed.
Socket lever in
locked position