51
Chapter 4: Motherboard Connections
LAN Port Enable/Disable
Use jumper JPL1 to enable or disable LAN1 - LAN4. Refer to the table below for jumper
settings.
LAN Port Enable/Disable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled (Default)
Pins 2-3
Disabled
Manufacturing Mode Select
Close pins 2-3 of jumper JPME2 to bypass SPI flash security and force the system to operate
in the manufacturing mode, which will allow the user to flash the system firmware from a host
server for system setting modifications. Refer to the table below for jumper settings.
Manufacturing Mode
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Normal (Default)
Pins 2-3
Manufacturing Mode
VGA Enable/Disable
Use jumper JPG1 to enable the onboard VGA connector. Refer to the table below for jumper
settings.
VGA Enable/Disable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled (Default)
Pins 2-3
Disabled
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the
system if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt
signal for the application that hangs. Watch Dog must also be enabled in BIOS. The default
setting is Reset.
Note:
When Watch Dog is enabled, users need to write their own application software to
disable it.
Watch Dog
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Reset (Default)
Pins 2-3
NMI
Open
Disabled
