47
Chapter 3: Maintenance and Component Installation
Figure 3-10. Removing a Dummy Drive from a Carrier
Installing a Storage Drive
1. Remove the dummy drive from the carrier by removing the screws.
2. Insert a drive into the carrier with the PCB side facing down and the connector end
toward the rear of the carrier. Align the drive in the carrier so that the screw holes line
up. Note that there are holes in the carrier marked “SATA” to aid in correct installation.
3. Secure the drive to the carrier with screws.
4. Insert the drive carrier into its bay with the carrier release handle on the top and the
release button on the bottom. When the carrier reaches the rear of the bay, the release
handle will retract.
5. Push the handle in until it clicks into its locked position.
