62
SuperServer 2049U-TR4 User's Manual
Power-Failure Throttling Enable/Disable
The Power-Failure Throttling jumper is located at J17. Close pins 1-2 of J17 to enable power
throttling feature. The default setting is the close pins 2-3 for normal operation. See the jumper
setting table below.
Power-Failure Throttling
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled
Pins 2-3
Normal
Management Engine (ME) Recovery
Use jumper JPME1 to select ME Firmware Recovery mode, which will limit resource
allocation for essential system operation only in order to maintain normal power operation
and management. In the single operation mode, online upgrade will be available via Recovery
mode. See the table below for jumper settings.
Manufacturer Mode
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Normal
Pins 2-3
ME Recovery
Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system
if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the
application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset.
Note:
When Watch Dog is enabled, the user needs to write their own application software
to disable it.
Watch Dog
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Reset
Pins 2-3
NMI
Open
Disabled
VGA Enable/Disable
Jumper Settings
Jumper Setting
Definition
Pins 1-2
Enabled
Pins 2-3
Disabled
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port, which is supported by the onboard BMC
controller. The default setting is Enabled.
Summary of Contents for SuperServer 2049U-TR4
Page 1: ...USER S MANUAL Revision 1 0 SuperServer 2049U TR4...
Page 46: ...SuperServer 2049U TR4 User s Manual 46 1 2 Figure 3 9 Removing a Drive Carrier...
Page 112: ...112 SuperServer 2049U TR4 User s Manual...
Page 141: ...Appendix E Traditional Chinese Version of Safety Warnings 141 1 2 3 4 5 1 2 3 4 1 2 3 4 1 2...
