SuperServer 2029P-C1R(T) User's Manual
36
Installing the Processor Heatsink Module (PHM)
1. Locate the triangle (pin 1) on the CPU socket, and locate the triangle (pin 1) at the
corner of the PHM that is closest to "1." (If you have difficulty locating pin 1, turn the
PHM upside down. On the underside of the CPU, you can see the hollow triangle
located next to a screw at the corner. Turn the PHM right side up, and you will see a
triangle marked on the processor clip at the same corner as hollow triangle.)
2. Align pin 1 corner of the PHM over pin 1 corner on the CPU socket.
3. Align the two holes at diagonal corners of the PHM onto the two guide posts on the
socket bracket and carefully drop the PHM onto the socket.
4. Use a T30 Torx-bit screwdriver to install four screws into the mounting holes on the
socket to securely attach the PHM onto the motherboard in the sequence of 1, 2, 3, and
4, as marked on the heatsink label. Gradually tighten each to assure even pressure.
Note
: Use only 12 foot-pounds of torque when tightening the screws to avoid damaging
the processor or the socket.
#1
#2
#3
#4
Small Guiding Post
Large Guiding Post
Oval D
T30 Torx Driver
Use a torque
of 12 lbf
Oval C
Printed Triangle
Mounting the Processor Heatsink Module
into the CPU socket (on the motherboard)
Tighten the screws in the
sequence of 1, 2, 3, 4 (top 3 quarter view)
Installing the Processor Heatsink Module
