Supermicro SUPERSERVER 2028TP-DTFR, User Manual, Page: 90 / 140

6-16
SUPERSERVER 2028TP-DTR/DTTR/DTFR USER'S MANUAL
6-10 Drive Bay Installation/Removal
Accessing the Drive Bays
SATA Drives: You do not need to access the inside of the chassis or remove power
to replace or swap the SATA drives. Proceed to the next step for instructions. You
must use 2.5" SATA drives in the system.
Note: Refer to the following FTP site for setup guidelines: <ftp://ftp.supermicro.com/
driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf> and Supermicro's website for
additional inmformation < http://www.supermicro.com/support/manuals/>.
The chassis contains two individual motherboards in separate node
drawers. Each serverboard node controls a set of twelve hard drives. Note that if
a serverboard node drawer is pulled out of the chassis, the hard drives associated
with that node will power down as well.
Serverboard Drawer Locations in the Chassis
Serverboard A
Controls HDDs A1 through A12
Serverboard B
Controls HDDs B1 through B12
Figure 6-14. Hard Drives and the Corresponding Serverboards
1
A
1
B