Supermicro Supero SUPERSERVER 2027PR-HTFR, User Manual

Page: 57 / 146

Chapter 5: Advanced Serverboard Setup
5-3
5-4 Processor and Heatsink Installation
Notes:
•
Always remove the power cord before adding, removing or changing a CPU.
•
When receiving a serverboard without a processor pre-installed, make sure that
the plastic CPU socket cap is in place and none of the socket pins are bent;
otherwise, contact your retailer immediately.
•
If you buy a CPU separately, use only an Intel-certifi ed, multi-directional heatsink.
•
Avoid placing direct pressure to the top of the processor package.
•
Install the processor into the CPU socket before installing the heatsink.
•
Refer to the Supermicro web site for updates on CPU support.
Release the lever
labeled "Open 1st"
Installing a CPU
1. There are two levers on the LGA
2011 socket. First press and
release the load lever labeled
"Open 1st".
OPEN 1st OPEN
1st
OPEN 1st OPEN
1st
Release the lever
labeled "Close 1st"
2. Press the second load lever
labeled "Close 1st" to release the
load plate from its locked position.