Chapter 20: System Management Commands
System Status
– 654 –
no hostname
name
- The name of this host. (Maximum length: 255 characters)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
Global Configuration
E
XAMPLE
Console(config)#hostname RD#1
Console(config)#
S
YSTEM
S
TATUS
This section describes commands used to display system information.
show access-list
tcam-utilization
This command shows utilization parameters for TCAM (Ternary Content
Addressable Memory), including the number policy control entries in use,
the number of free entries, and the overall percentage of TCAM in use.
Table 20-3: System Status Commands
Command
Function
Mode
Shows utilization parameters for TCAM
PE
Shows memory utilization parameters
NE, PE
Shows CPU utilization parameters
NE, PE
Shows the CPU utilization watermark and threshold
NE, PE
Shows CPU utilization per process
NE, PE
Displays the configuration data currently in use
PE
Displays the contents of the configuration file (stored
in flash memory) that is used to start up the system
PE
Displays system information
NE, PE
Displays a detailed list of system settings designed to
help technical support resolve configuration or
functional problems
PE
Shows all active console and Telnet sessions, including
user name, idle time, and IP address of Telnet clients
NE, PE
Displays version information for the system
NE, PE
Shows if watchdog debugging is enabled
PE
Monitors key processes, and automatically reboots the
system if any of these processes are not responding
correctly
PE
Summary of Contents for SSE-G2252
