Chapter 20: System Management Commands
Frame Size
– 664 –
Console#
show watchdog
This command shows if watchdog debugging is enabled.
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
Console#show watchdog
Software Watchdog Information
Status : Enabled
Console#
watchdog software
This command monitors key processes, and automatically reboots the
system if any of these processes are not responding correctly.
S
YNTAX
watchdog software
{
disable
|
enable
}
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
Console#watchdog
Console#
F
RAME
S
IZE
This section describes commands used to configure the Ethernet frame size
on the switch.
jumbo frame
This command enables support for Layer 2 jumbo frames for Gigabit
Ethernet ports. Use the
no
form to disable it.
Table 20-5: Frame Size Commands
Command
Function
Mode
Enables support for jumbo frames
GC
Summary of Contents for SSE-G2252
