Supermicro SSE-G2252, User Manual

Page: 1043 / 1401

Chapter 35: ERPS Commands
– 1056 –
S
YNTAX
meg-level level
level - The maintenance entity group (MEG) level which provides a
communication channel for ring automatic protection switching
(R-APS) information. (Range: 0-7)
D
EFAULT
S
ETTING
1
C
OMMAND
M
ODE
ERPS Configuration
C
OMMAND
U
SAGE
•
This parameter is used to ensure that received R-APS PDUs are directed
for this ring. A unique level should be configured for each local ring if
there are many R-APS PDUs passing through this switch.
•
If CFM continuity check messages are used to monitor the link status of
an ERPS ring node as specified by the mep-monitor command, then the
MEG level set by the meg-level command must match the authorized
maintenance level of the CFM domain to which the specified MEP
belongs. The MEP’s primary VLAN must also be the same as that used
for the ERPS ring’s control VLAN.
E
XAMPLE
Console(config-erps)#meg-level 0
Console(config-erps)#
R
ELATED
C
OMMANDS
ethernet cfm domain (1275)
ethernet cfm mep (1279)
mep-monitor
This command specifies the CFM MEPs used to monitor the link on a ring
node. Use the no form to restore the default setting.
S
YNTAX
mep-monitor { east | west } mep mpid
east - Connects to next ring node to the east.
west - Connects to next ring node to the west.
mpid – Maintenance end point identifier. (Range: 1-8191)
D
EFAULT
S
ETTING
None
C
OMMAND
M
ODE
ERPS Configuration