Supermicro SSE-G2252, User Manual

Page: 1265 / 1401

Chapter 41: CFM Commands
– 1279 –
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name rd vlan 1 mip-creation default
Console(config-ether-cfm)#
ma index
name-format
This command specifies the name format for the maintenance association
as IEEE 802.1ag character based, or ITU-T SG13/SG15 Y.1731 defined ICC-
based format. Use the no form to restore the default setting.
S
YNTAX
ma index index name-format { character-string | icc-based }
no ma index index name-format
index – MA identifier. (Range: 1-2147483647)
character-string – IEEE 802.1ag defined character string format.
This is an IETF RFC 2579 DisplayString.
icc-based – ITU-T SG13/SG15 Y.1731 defined ICC based format.
D
EFAULT
S
ETTING
character-string
C
OMMAND
M
ODE
CFM Domain Configuration
E
XAMPLE
This example specifies the name format as character string.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#ma index 1 name-format character-string
Console(config-ether-cfm)#
ethernet cfm mep
This command sets an interface as a domain boundary, defines it as a
maintenance end point (MEP), and sets direction of the MEP in regard to
sending and receiving CFM messages. Use the no form to delete a MEP.
S
YNTAX
ethernet cfm mep mpid mpid md domain-name ma ma-name [ up ]
no ethernet cfm mep mpid mpid ma ma-name
mpid – Maintenance end point identifier. (Range: 1-8191)
domain-name – Domain name. (Range: 1-43 alphanumeric
characters)
ma-name – Maintenance association name. (Range: 1-43
alphanumeric characters)
up – Indicates that the MEP faces inward toward the switch cross-
connect matrix, and transmits CFM messages towards, and receives