Supermicro MBI-6219G-T, User Manual

Page: 34 / 85

MBI-6219G-T MicroBlade Module User’s Manual
2
Removing a MicroBlade Module Unit from the Enclosure
Although the MicroBlade module system may continue to run, individual MicroBlade
modules should always be powered down before removing them from the enclosure.
Removing a MicroBlade Module Unit from the Enclosure
1. Power down the MicroBlade module unit (see "Powering Down a MicroBlade
Module Unit" above).
2. Squeeze both handles to depress the red sections then pull out both handles
completely and use them to pull the MicroBlade module unit from the enclosure.
Note: MicroBlade modules can be hot-plugged from the enclosure.
Installing a Blade Unit into the Enclosure
Use the procedure below to install a blade unit into an enclosure.
Installing a MicroBlade Module Unit into the Enclosure
1. Slowly push the MicroBlade module unit into its bay with the handles fully pulled out
(see Figure 3-1 ).
2. When the MicroBlade module stops, push the handles back in to their locked
position, making sure the notches in both handles catch the lip of the enclosure.
Note: MicroBlade modules can be Hot-Plugged into the enclosure.
Caution: Use extreme caution when inserting a MicroBlade module into the
enclosure
. If the MicroBlade module's power connector becomes damaged, it can damage
pins on other MicroBlade module bays that it is inserted into.