Supermicro L2/L3 Switches Configuration Guide
22
Gi0/19 not connected Full 1 Gbps Auto
Gi0/20 not connected Full 1 Gbps Auto
Gi0/21 not connected Half 1 Gbps Auto
Gi0/22 not connected Full 1 Gbps No-Negotiation
Gi0/23 not connected Half 1 Gbps Auto
Gi0/24 not connected Half 1 Gbps Auto
Ex0/1 not connected Full 10 Gbps No-Negotiation
Ex0/2 not connected Full 10 Gbps No-Negotiation
Ex0/3 not connected Full 10 Gbps No-Negotiation
1.4.3
Speed
Interface speed can be configured for physical interfaces when auto negotiation is disabled.
1Gb RJ45 interfaces can be configured to operate at 10Mbps, 100Mbps or 1000Mbps speed.
10Gb interfaces in SSE-G24-TG4, SSE-G48-TG4, SBM-GEM-X2C, SBM-GEM-X2C+ and SBM-GEM-X3S+
switches can operate only at the fixed 10Gb speed.
10Gb interfaces in SSE-X24S, SBM-XEM-X10S, SSE-X3348S and SSE-X3348T switches can be configurable
to operate at 1Gb or 10Gb speed.
40Gb interfaces are fixed to operate only at the 40Gb speed.
Follow the steps below to configure the interface speed.
Step Command
Description
Step 1
configure terminal
Enters the configuration mode.
Step 2
interface <
interface-type
><
interface-id
>
or
interface range
<
interface-type><interface-id> ….
Enters the interface configuration
mode.
interface-type
– may be any of the
following:
gigabitethernet – gi
extreme-ethernet – ex
interface-id
is in
slot/port
format for all
physical interfaces.
To configure multiple interfaces, use
the “
interface range
…” command. To
provide a range, use a hyphen (-)
