Supermicro 8015C-T, User Manual

Page: 87 / 118

Chapter 7: BIOS
7-21
Parity Checking
This option allows the user to enable or disable SB IDCHK# and PCI SERR# Parity
Checking. The options are Enabled and Disabled .
Wait for ‘F1’ If Error
Select Enable to allow the system to wait for the user to press F1 when an error
occurs. The options are Enabled and Disabled.
Hit ‘DEL’ Message Display
Select Enabled to display the Setup Message: "Press DEL to run Setup" when the
user hits the DEL key. The options are Enabled and Disabled.
Interrupt 19 Capture
Select Enabled to allow Option ROMs to trap Interrupt 19. The options are Enabled
and Disabled .
Boot Graphic Adapter Priority
This feature allows the user to select which graphics controller to be used as the
primary boot device. The options are Auto and Onboard VGA.
Watch Dog Timer
If enabled, this option will automatically reset the system if the system is not active
for more than 5 minutes. The options are Enabled and Disabled .
Boot Device Priority
This feature allows the user to specify the sequence of priority for the Boot De-
vice.
The settings are 1st Floppy Drive, CD ROM, ATAPI CDROM and Disabled. The
default settings are the following:
· 1st boot device – 1st Floppy Drive
· 2nd boot device – Network: IBA GE Slot
· 3rd boot device – Network: IBA GE Slot
Hard Disk Drive
This feature allows the user to specify the boot sequence from available HDDs.
1st Drive
This option allow the user to specify the boot sequence for the fi rst HDD.
· 1st boot device