Supermicro 8015C-T, User Manual

Page: 48 / 118

5-16
S
UPER
S
ERVER 8015C-T User's Manual
Serial Ports
Two serial ports are included on the
serverboard. COM1 is a backpanel
port and COM2 is a header located
near the onboard battery. See the
table on the right for pin defi nitions.
Serial Port Pin Defi nitions
(COM1/COM2)
Pin # Defi nition Pin # Defi nition
1 DCD 6 DSR
2 RXD 7 RTS
3 TXD 8 CTS
4 DTR 9 RI
5 Ground 10 NC
Universal Serial Bus (USB)
There are two Universal Serial Bus
ports located on the I/O panel and
three additional USB headers located
on the serverboard. The headers can
be used to provide front side USB
access (cables not included). See the
table on the right for pin defi nitions.
Universal Serial Bus
Pin Defi nitions (USB)
USB0/1
Pin # Defi nition
USB2/3/4
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 N/A 5 Key
Power LED/Speaker
On JD1 header, pins 1-3 are for a
power LED and pins 4-7 are for the
speaker. Close pins 4-7 with a jumper
to use an external speaker. If you wish
to use the onboard speaker, please
close pins 6-7. See the table on the
right for speaker pin defi nitions.
Power LED/Speaker
Connector (JD1)
Pin Setting Defi nition
Pins 6-7 Internal Speaker
Pins 4-7 External Speaker
SGPIO Header
The SGPIO (Serial General Purpose
Input/Output) headers are located at
J15/J16. These headers are used to
"talk to" a system-monitoring chip on
the backplane. See the table on the
right for pin defi nitions.
SGPIO Header
Pin Defi nitions (J15/J16)
Pin# Defi nition Pin Defi nition
1 *NC 2 *NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 *NC
NC = No Connection