Supermicro 7044H-82, User Manual

Page: 109 / 124

Appendix B: Software Installation
B-9
Notes
1. Before adding a new drive to an array, back up any data contained on
the new drive. Otherwise, all data will be lost.
2. If you stop the build or clear process on a RAID 1 from ACU, you can
restart it by pressing Ctrl+R .
3. A RAID 1 created using the Quick Init option may return some data mis-
compares if you later run a consistency check. This is normal and is not a
cause for concern.
4. The ACU allows you to use drives of different sizes in a RAID. However,
during a build operation, only the smaller drive can be selected as the
source or first drive.
5. When migrating from single volume to RAID 0, migrating from a larger
drive to a smaller drive is allowed. However, the destination drive must be
at least half the capacity of the source drive.
6. Adaptec does not recommend that you migrate or build an array on
Windows dynamic disks (volumes), as it will result in data loss.
Warning : Do not interrupt the creation of RAID 0 using the Migrate option.
If you do, you will not be able to restart or to recover the data that was on
the source drive.