Supermicro 6048R-E1CR24L, User Manual

Page: 78 / 142

6-2
S
UPER
S
TORAGE
S
YSTEM 6048R-E1CR24L User's Manual
Figure 6-1. Front and Rear Chassis Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection.
Connect the cable from JF1 on the serverboard to the Control Panel PCB (printed
circuit board). Make sure the red wire plugs into pin 1 on both connectors. Pull all
excess cabling out of the airflow path. The LEDs inform you of system status. See
Chapter 3 for details on the LEDs and the control panel buttons. Details on JF1
can be found in Chapter 5.
Hard Drives (24) Control Panel
Power Supplies (2)
I/O Ports Optional Rear Hot-Swap Drive Bays PCI Expansion Slots
JBOD Expansion Ports Hardware RAID Add-on Card
1
0
9
8
7
6
5
4
3
2
18
17
16
10
13
12
14
15
11
19
20
23
22
21
Note: numbers indicate the logical drive bay locations.