Supermicro 6027AX-72RF-HFT1, User Manual

Page: 84 / 126

Chapter 6: Advanced Chassis Setup
6-7
Installing a Hard Drive into a Drive Carrier
1. Remove the screws securing the dummy drive to the carrier.
2. Remove the dummy drive from the carrier.
3. Install a new drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
4. Secure the hard drive by tightening all six screws.
5. Replace the drive carrier into the chassis bay, making sure that the drive car-
rier handle is completely closed.
6. Install a new drive into the carrier with the printed circuit board side facing
down so that the mounting holes align with those in the carrier.
7. Secure the hard drive by tightening all six screws.
8. Replace the drive carrier into the chassis bay, making sure that the drive car-
rier handle is completely closed.
Figure 6-5. Removing a Dummy Drive from a Carrier
1 1
1
1
Warning: Except for short periods of time (swapping hard drives), do not
operate the server with the hard drives removed from the bays.