The appliance is designed to be floor mounted only. DO NOT RECESS ANY PART OF THE APPLIANCE.
The appliance is supplied with a pre-wired three pin BS1363 plug (13 Amp fuse rated), and 1.8 metre cable. A standard switched outlet/wall
socket, (including earth provision), must therefore be located within this distance, and be easily accessible in order to isolate the supply for
maintenance and cleaning. This socket must not be mounted behind or above the appliance.
IMPORTANT: THIS APPLIANCE MUST BE EARTHED.
1.0 IMPORTANT NOTES
I N S TA L L AT I O N & U S E R I N S T RU C T I O N S
©
2015 Focal Point Fires plc.
2
GB IE
2.0 APPLIANCE DATA
Weight (kg):
32 kg
Dimensions (mm):
H 855 x W 850 x D 235
Voltage (Volts):
230-240V a.c. 50Hz
Heating Elements:
1800 Watts
Supply Cord:
1.8 metres
Supply Plug:
BS 1363, 13A Fused
Location:
Indoor Use
Lighting:
LED
Section Contents
Page No.
1.0
Important Notes
2
2.0
Appliance Data
2
3.0
Electrical Installation Requirements
2
4.0
Site Requirements
3
5.0
Clearances to Combustible Materials
3
6.0
Unpacking the Appliance
3
Section Contents
Page No.
7.0
Component Checklist
3
8.0
Operating the Appliance
3
9.0
Safety Cut-Out System
4
10.0
Cleaning and Maintenance
4
11.0
Servicing
4
12.0
Appliance Dimensions
5
13.0
Guarantee - Terms and Conditions
5
IMPORTANT - THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE.
When using this electrical appliance, basic precautions should be followed to reduce the risk of fire, electric shock and injury to person, including the follow-
ing:
• This heater must be used on an AC supply only and the voltage marked on the heater’s rating label must correspond to the supply voltage.
• Do not switch the appliance on until it is properly installed as described in this manual.
• The heater must not be located immediately above a socket outlet.
• Keep furniture, curtains and other fabric material away from the appliance.
• Do not leave the appliance unattended during use.
• This appliance is intended for household use and should not be used for industrial purposes.
• From time to time, check the cord for damage. Never use the appliance if the cord or any part of the appliance shows signs of damage. A damaged
cord must only be replaced by a qualified person.
• Do not operate this appliance with a damaged plug or cord, after a malfunction or after being dropped or damaged in any way.
• Repairs to electrical appliances should only be performed by a qualified electrician. Improper repairs may place the user at serious risk.
• Do not run the mains cable under carpets, rugs etc.
• Do not cover or obstruct the heater in any way. Overheating will result if it is accidentally covered.
• Never immerse the product in water or any other liquids.
• Do not use this heater where it may come into contact with water e.g. in bathrooms, shower rooms etc.
• Do not use the appliance outdoors.
• Before cleaning the appliance, ensure it is unplugged from the power and that it is completely cool.
• Do not clean the appliance with abrasive chemicals.
• Never use accessories that are not recommended or supplied by the manufacturer. It could cause danger to the user or damage to the appliance.
• There are no other replacement parts. All other servicing should be referred to a qualified engineer.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
•
CAUTION!
In order to avoid a hazard due to inadvertent resetting of the thermal cut out, this appliance must not be supplied through an
external switching device such as a timer or connected to a circuit that is regularly switched on and off by the utility.
•
CAUTION!
Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vunera-
ble people are present.
• Do not insert or allow foreign objects to enter the inlet or outlet vents as this may result in electric shock, fire or damage to the appliance.
• Do not install the fire using an extension cord.
• Unplug from the mains supply if the appliance is not to be used for long periods.
•
WARNING!
This heater is equipped with a device to control the room temperature. Do not use this heater in small rooms when they are
occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
•
WARNING!
Children of less than 3 years should be kept away unless continuously supervised. Children aged 3 years and less than 8 years shall
only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervi-
sion or instruction concerning use of the appliance in a safe way and understand the hazards involed. Children aged from 3 years and less than 8 years
shall not plug in, regulate and clean the appliance or perform user maintenance.
DO NOT recess any part of appliance into the wall.
The appliance is supplied with a pre-wired three pin plug (13 Amp fuse rated) and 1.8 metres of electrical cable. It is therefore necessary for a
suitable electrical socket to be located within this distance and be easily accessible.
3.0 ELECTRICAL INSTALLATION REQUIREMENTS
