OFF TIMER
Press to set the OFF TIMER
10m - 20m - 30m - 40m - 50m - 1H - 2H - 3H - 4H - 5H - 6H - 7H - 8H - 9H - (LOOP)
EMBER/FUEL BED EFFECT
Press to select the dynamic fuel bed effect
CONTROL PANEL
POWER ON/OFF
FLAME BRIGHTNESS (5 settings)
Press to adjust the brightness level
FULL (5) - HIGH (4) - MEDIUM (3) - LOW (2) - DIM (1) - (LOOP)
HEATING (7 settings)
Press
∧
/
∨
to adjust the temperature level
60
℃/
99°F - 30
℃/
86°F - 28
℃/
82°F - 26
℃
/
78°F - 24
℃
/
75°F - 22
℃
/
71°F - OFF - (LOOP)
Press button for 10s to convert between
℃
and
℉
(model dependent)
EMBER/FUEL BED EFFECT
Press to select the dynamic fuel bed effect
This appliance has a safety cut-out system fitted which will activate if the air inlets or heater outlets are obstructed. For safety reasons the fire
WILL NOT switch on again automatically. NOTE: The LED display panel will remain operational if the cut-out is activated, only the fan heater
elements are prevented from operating.
The following procedure must be carried out before the fire can be operated again:
1. Unplug the power supply cable at the outlet socket and place all switches to off at the appliance.
2. Leave the fire OFF for a period of not less than 10 minutes, ensuring any obstructions are removed.
3. Plug in the power supply cable at the outlet socket, and then switch on at the appliance.
If an attempt to switch on is made before the safety cut-out has reset, the heaters may cut-out for a further period of time. If the sequence has
been followed correctly and the heaters still fail to function, check the power supply cable plug is plugged in at the outlet socket. If this is not
the cause, call an electrician.
ALWAYS DISCONNECT THE APPLIANCE AT THE SUPPLY OUTLET SOCKET BEFORE UNDERTAKING ANY CLEANING.
Except for periodic cleaning of dust, there are no specific requirements for care, other than regular cleaning of the general appliance. A wipe
with a dry cloth is normally sufficient. DO NOT use abrasive cleaners as they can damage the finish. Make sure the heater outlet grille (locat-
ed next to the switches), and the air inlet mesh grilles (located either side of the outlet grille) are kept clear of dust, pet hair and other airborne
household matter. These should be vacuum cleaned periodically using a brush attachment.
PLASTIC SCREEN - This should only be cleaned using a suitable glass cleaner. Test on a small area first.
8.0 OPERATING THE APPLIANCE
- CONTINUED
GB IE
4
©
2015 Focal Point Fires plc.
9.0 SAFETY CUT-OUT SYSTEM
10.0 CLEANING AND MAINTENANCE
11.0 SERVICING
There are no internal user serviceable parts.
Check security of supply cable and connections. If the supply cable becomes damaged, it must be replaced by a service agent or competent per-
son, such as a qualified electrician.
The wires in the cable are coloured in accordance with the following code:
LIVE
- Brown
NEUTRAL
- Blue
EARTH
- Green/Yellow
Refer to Section 2.0, Appliance Data for fuse specification. Excluding fuses, use only genuine manufacturers spare parts available from your sup-
plier.
