If you have any questions during the setup process, please call a SuperCloset representative at 1.877.476.9787
3.
At this time, add water to the reservoirs. When filled to the appropriate
levels, the SuperCloner 14 reservoir will hold about 1.5 -2 gallons of water.
The SuperPonic 8 reservoir will hold about 2-3 gallons.
Almost Done
4.
Plug the GFCI Protector (image b) into any 110v wall socket. With the power
strip turned OFF, plug the power strip into the GFCI Protector.
DO NOT POWER UP YOUR CABINET YET!
5.
Now that everything is plugged into the power strip, lets verify some
important steps:
6.
After verifying all of the above, it’s time to turn on your SuperCloset. Turn the
power strip switch to the ON position, and the system should spring to life
before your very eyes!
1) LED Light is properly hung.
2) Watering System tubes are securely fastened to the top of the Water Pump.
3) Both Reservoirs are filled with water and Water Pump is fully submerged.
4) Air Pumps are next to (NOT IN!) the reservoir.
5) Light Power Cord is plugged into Smart Plug#1.
6) Water Pump Power Cords are plugged into Smart Plug #2.
7) Power Strip is off and plugged into the GFCI Protector.
Your reservoir should always be filled at least halfway. In the
beginning stages, we recommend maintaining a water level
extremely close (½” - 1”) from the bottom of the net cups, but not
touching (image a). The water should remain at this level until an
evident root structure begins to develop.
SUPER GROW TIP:
NOTE:
EARLY STAGE
12:00 - 12:03
4:00 - 4:03
8:00 - 8:03
12:00 - 12:03
4:00 - 4:03
8:00 - 8:03
Water pump schedule suggestions.
Run for 3 minutes approximately every 4 hours.
a
b
