If you have any questions during the setup process, please call a SuperCloset representative at 1.877.476.9787
4.
Locate and unpack two of the bubble wrapped T5 Light Strips located in your
package (image a). Use the short “daisy chain” connector found inside the
light packaging to connect the two T5 lights to one another (image b). Then
attach one power cord to the end of one of the T5 lights.
5.
The T5s comes equipped with magnetic backing and is mounted to the
underside ceiling of the cloning chamber (upper chamber) in this manner
(image c).
6.
Locate the Internal Circulation Fan (image d). Note the “S” hook connected
to the base of the Fan. This hook will fit into the notches located on the
backside of the inner door frame (image e). Mount the Fan on one of the
lower notches. As your plants grow taller, move the Fan to the upper
notches. Ideally the Fan will blow air across the top of the plants. Thread
cord through the upper hole found on the lower interior of the cabinet (same
as the Light power cord).
7.
Locate the Thermometer/Hygrometer (image f). Remove the battery cover
and remove the plastic safety blocker from the battery terminal. Use the
included Velcro Strips to affix your Thermometer/Hygrometer to the inside of
your cabinet. The best placement for this is towards the top of the cabinet,
either on the side or back wall.
8.
Run the external probe to the outside of the cabinet, through the nearest
Elbow. Make sure the probe is not touching any surface on the out side of
the cabinet as this will provide false readings.
Setting up the SuperCloset
a
b
c
d
e
X2
