Superabrasive Lavina 25LM-X, User Manual

Page: 9 / 41

Superabrasive User Manual Original Language Lavina® 25LM-X / Lavina® 25LM-X-HV 1/2016
STORAGE
Always store and transport the Lavina® X
machine in a dry place. Never transport the
Lavina® X machine unprotected; it may be
damaged if transported unprotected during
rain or snow.
When storing the machine the temperature may fall down to or to less than 32F (or 0
o
C) you should empty the water from the
system using the following steps:
- Pull out the hose of the tank (Fig.3.9)
- Using compressed air blow out the water from the system for the two positions of the turn-cock (Fig. 3.10, Fig. 3.11).
4. OPERATION
PRELIMINARY CONTROLS
Inspect the working area as explained in the safety instructions. For wet use, fill the water tank when the electrical cable is
disconnected. Connect the vacuum extractor and ensure that the vacuum hose is clear and that it will easily follow the machine. Plug
in the machine and make sure that the power cord is free to follow the direction of the working Lavina® X machine.
WATER FLOW CONTROL UNIT
The operator can choose the water sprayer in the
front when the tap is in the horizontal position
(Fig.4.1), the water will spray under the cover of the
machine when the level is in the vertical position
(Fig.4.2).The flow regulating valve located on the
tank (Fig.4.3) is increasing or reducing the water
flow to the working area – in front of the machine
or under the main head cover of the machine.
ADJUSTING AND MOUNTING TOOLS
The Holder A41 in LAVINA® X can work with either 3 or 6 buffers
which will change its elasticity. You can make the change after
dismounting the holder as per the instruction in
TROUBLESHOOTING.
In Lavina 25L-X the holder is initially
mounted with 6 buffers.
Mount the tools only after ensuring that there is enough
diamond bond material left. Be sure that the plates are always
clean before mounting. WARNING: Always secure the “QuickChange” pads with the security plate (Fig.4.4), lock with the tool holder
key (Fig.5.3). Diamond tools with Velcro are attached to three 9inch foam plates (Fig.4.5). The foam plates are mounted on the key
lock (butterfly). Always use the tool holder key (Fig.5.3).
Figure 3.9
Figure 3.10
Figure 3.11
Figure 4.5
Figure 4.4
Figure 4.2 Figure 4.3
Figure 4.1
9