Superabrasive Owner’s Manual orginal language –
Lavina 20®N Pro/20®NHV Pro
2/2012
17
MOUNTING THE BELT WITH SA OR SAM HOLDER
Bolt on the belt-replacing tool according the picture (Fig. 8.32). See the belt-replacing tool is in down position (Fig.
8.33). Lay the belt with only ½ of its width showing over the pulleys (Fig. 8.33), and slowly begin to turn the belt
replacing tool and the pulleys. Keep turning until the belt is on the pulleys (Fig. 8.34). Only putting ½ of the belt width is
very important otherwise if the belt is initially mounted complete over the pulleys, it will be “over” tensioned and
destroyed.
ATTENTION: NEVER “OVER” TENSION THE BELT, THE BELT WILL BE DAMAGED AND IT
WILL NEVER RECOVER ITS ORIGINAL TENSION
Apply the seal ring in the channel of the aluminum cover and close the machine.
Reassemble in the same manner. Do not forget to put back or replace the “O” ring
(see Fig. 8.31).
Your Lavina20®N Pro/20®NHV Pro is now ready for use!
MOTOR CONNECTION
In case of changing the motor, please check the cable connection to your motor.
Lavina20® N Pro
The motor is connected in “Delta”
(Triangle) 230 Volt, reminder for
the wire connection of the motor.
Lavina 20®NHV Pro
The motor is connected in “Star”
380 Volt, reminder for the
wire connection of the motor.
Figure 8.32
Figure 8.33
Figure 8.34
Figure 8.35
Figure 8.36
Figure 8.37
