Step 5 Route Cable
1. Connect the bolt end of Cable (#16) to the Selector pin pre-assemblied with
Top Plate (#22).
2. Pass Cable (#16) through the tow middle hole on the Main Upright (#01),
then route over two Pulley4.5" (#29) and secure them to Double Pulley
Bracket welded on Main Upright (#01), using:
Bolts M10*50(#50)
four Washers φ11*φ20*1.5 (#64)
two Allen
two
Allen
two
Allen
Allen
Nylon Locknuts M10 (#59)
one
Bolt M10*50(#50)
Washers φ11*φ20*1.5 (#64)
one Nylon Locknut M10 (#59)
one
Bolt M10*50(#50)
two Washers φ11*φ20*1.5 (#64)
one Nylon Locknut M10 (#59)
one
Bolt M10*50(#50)
one Washer φ11*φ20*1.5 (#64)
3. Route over one Pulley4.5" (#29),and secure it to bracket welded on Rear
Main Cross(#07), using:
4. Route over one Pulley4.5" (#29),and secure it to bracket welded on Front
Main Cross(#03), using:
5. Route over one Pulley4.5" (#29),and secure it to bracket welded on
Extension (#02), using:
6. Connect the end of Cable (#16) to Cable end Bracket welded on Cam (#05),
then using: one Flat Head Screw M4*20 (#55) to stop the Cable end out.
Make sure the Cable is in the groove of every pulleys and to tighten all bolts
and nuts by wrench.
11
