1
2
Made a Z-bend on one end of the rod
using Z bender.
Connect the female plug of the 300mm
extension with the male plug of the
servo. Use transparent tape to circle
the connecting place for preventing
loosening.
Tight a cotton line on the male plug of
the extension. Route the line through
the pre-drilled holes in the rid. Cut off
the cotton line when the extension is
out of the hole.
Take the control horn and M2
x15
screw out the hardware. Assemble
just like the illustrator. Please note
that the control horn must
beperpendicular to the control
surface when secure the control
horn.
The whole accessories including in this kit.
Recommended radio and electronic equipment (Not included in kit):
4 Channels radio
Mini servos x 4 pieces
Receiver
300mm extension x 2 pieces
Optional accessories
Recommended radio and electronic equipment (Not included in kit)
Required Tools and Adhesives
#2421
40A brushless
Speed Control
#2820
940
KV
brushless motor
Epoxy 5-minute
Small Phillips Screwdriver
Pen
2mm driller Curved scissors
CA glue
Z bender
1.5mm Hex wrench
Hobby Knife
Ruler
Pliers
Y-harness x 1 piece
40A speed control
Li-Po 2100mA 3 cells battery pack
Propeller:
12X8
Paper Tape
Lubricating Oil
Soldering Iron
Solder
Spray epoxy on the wing joiner and
insert into the main wing for
securing the A section and B
section together. Please note the
B section must be 4 degree above
the horizontal and its wing tip will
be 42mm above the horizontal.
Spray
S
uper glue
on the hinges.
Use hinges to connect the main
wing with aileron and secure with
M2x6mm tapping screws. Use
hinges to connect the tail wing with
rudder and elevator. Secure the
hinges in place with M2x5mm
tapping screws.
A
B
A
B
S
uper glue
