14
www.
Supercircuits
.com
SECTION 3: SYSTEM SETUP
Arrange the cables within the box so they are packed along the left side as shown above, then reattach the AVSI switch cover
using the two hex screws removed earlier.
3.5 Connect the CAB-SWITCH cable to the recorder alarm ter-
minals and to 12 Vdc power
At the back panel of the recorder, do the following:
1.
Remove about 2” of insulating sheath from the end of the CAB-SWITCH cable.
2.
Unravel the red and black pair from the green and white pair, then strip 1/4” of insulation from each of the four wires using a
22 gauge wire stripping tool.
3.
Connect the CAB-SWITCH cable red and black wires to a
FEMALE-POW power cable
screw-down terminals, pairing the
red wire to the red wire of the power cable, and the black wire to the black wire of the power cable. See the photo below.
