11
AVSI-10 Interview Room System Setup and User Guide
SECTION 3: SYSTEM SETUP
5.
Strip about 3/8 inch of insulation from both the red and black leads.
6.
Connect the red, black, and drain leads to the A, B and C terminations respectively on the back of the microphone. See the
photo below.
A, B, C
terminations
Sensitivity
switch
A: 12 Vdc B: Audio C: Ground
Base Station
Microphone
A B C
7.
At the Base Station, strip the insulation from the end as was done at the microphone, and then secure the red, black and
drain wires to the A, B and C terminals respectively on the back of the unit. See the photo above.
8.
Connect one of the audio
RCA patch cables
to the
AUDIO OUTPUT
jack on the back of the base station, and then to
AUDIO IN 1
port on the back of the recorder. See the photo below.
Audio RCA
patch cables
AUDIO IN
1 port
Louroe Base Station
Wire to speakers
Wire to
power adapter
Wire to
microphone
AUDIO OUT
VGA port
Audio adapter
