Super B Epsilon SB12V1200Wh-M, Manual

Page: 21 / 50

Be in charge
Super B
21
4. Installation
4.1. General information
! Warning! Do not disassemble, crush, or puncture the Li-Ion battery.
! Warning! Never install or use a damaged battery.
When connecting several batteries in parallel, always use batteries of the same brand, type,
age, capacity and state of charge.
4.2. Unpacking
Check the battery for damage after unpacking. If the battery is damaged, contact your
reseller or Super B. Do not install or use the battery if it is damaged!
4.3. Preparing the battery for use
4.3.1. Placement of the battery
Before it is used, the Li-Ion battery must be positioned in such a way that it will not move
around in its compartment during use.
Use appropriate LN5 fastening brackets for mounting.
4.3.2. Set battery in normal operation mode
The Li-Ion battery is pre-programmed in storage mode. Before it is used, the Li-Ion battery
must be set up in normal operation mode.
The Li-Ion battery can be set to normal operation mode by one of the following procedures:
• Press the S1 Push button for 2 seconds.
• Connect the battery to the charger (see Chapter 5.2 Charging).
• Charge before use
4.4. Connection wires
Use appropriate wire for the connection wires to ensure no overheating or unnecessary
losses occur. Consult the SAE-J378 or ISO 10133:2012 standards to determine the appropriate
wire properties. Use appropriate fuses matching the wires and load. See Appendix IV for
more details.
4.4.1. Connecting power cables with automotive type terminals
1. Connect the load or charger to the X2 (+) terminal of the battery. (Figure 1)
! Warning! Do not connect the X1 (-) terminal first as this may lead to short circuits.
2. Connect the load or charger to the X1 (-) terminal of the battery. (Figure 1)