Harness User’s manual
S
UP’AIR
_
ACCESS AIRBAG
Page 15
SUP’AIR manufactures its harnesses in Europe. Most of the components used are Made in Europe.
ACCESS AIRBAG
Installing the reserve parachute.
A
F
Reserve riser protective
sleeve.
Lower flap.
B
G
Left upper flap.
C
H
Left lower flap.
D
I
E
J
Reserve parachute risers.
- Six (6) flap dorsal pocket.
- Locking via one (1) safety pin.
- Handle «B» ( Ref.: POIB ).
- 3 to 8,5 liters.
Adaptable to the SUP’AIR and other round
reserve parachutes only ( not the Rogallo type
).
Possibility to position the reserve parachute
handle to the right or to the left.
Right upper flap.
Right lower flap.
K
L
« B » reserve parachute
handle.
Reserve parachute sur-
plus lines (about 1 meter).
Reserve parachute folded
in its POD.
Reserve parachute parachute
pocket characteristics. :
Installing the reserve parachute in its container.
A
F
B
G
C
H
D
I
E
J
K
L
Upper flap.
Reserve parachute single
riser.
1.
- Place the risers « I » underneath the riser the protective sleeve « A » of
the chosen side.
- Then push them between flap « B » and the upper flap «G» to tuck away
the risers and reserve parachute lines excess « J » to the bottom of the
pocket.
- Place the reserve parachute over them.
- Pre-position the reserve parachute handle on the same risers side.
2.
-
Take a small piece of line to help with the installation procedure.
- Push it through loop #1 ( D marker ).
- Using the piece of line pull loop #1 through grommet #2 – flap (E)...
- then inside grommet #3 – flap (B)
- then inside grommet #4 – flap (C)
1
2
3
4
6
If your reserve
parachute volume
is too small, add
the foam wedge
to the end of the
reserve parachute
pocket ( ask your
dealer how to pro-
ceed if uncertain).
A
1
