4. INDUCTANCE (L) MEASUREMENT
PROCEDURE
1)Slide the " LC/R select switch " ( 3-3, Fig. 1 ) to the " LC "
position.
2)Rotate the function switch for the maximum expected
inductance range.
3)
Fully discharge any charged inductors.
4)Insert the tested inductor into socket " L/C Measuring
input terminal 1 " ( 3-5, Fig. 1 ). Alternatively, connect
the inductor to " L/C Measuring input terminal 2 " ( 3-6,
Fig. 1 ). via using the measuring alligators supplied .
Note :
a. If the inductance value is unmarked start with the
highest range and keep decreasing until a suitable
reading is obtained.
b. Measurement of very low inductance should be
performed using extremely short leads in order to
avoid introducing any stray inductance.
c. This instruments is not intended for determining the
" Q " factor for the inductor. Misleading readings may
be obtained if the measurement of the inductance of
a resistor is attempted.
5. CAPACITANCE (C) MEASUREMENT
PROCEDURE
1)Slide the " LC/R select switch " ( 3-3, Fig. 1 ) to the " LC "
position.
7