6. RESISTANCE (R) MEASUREMENT
PROCEDURE
1)Slide the " LC/R select switch " ( 3-3, Fig. 1 ) to the " R "
position.
2)Rotate the function switch for the maximum expected
resistance range.
3)Connect the tested resistor into socket " Resistance
Measuring input terminal " ( 3-6, Fig. 1 ) via using
the measuring alligators supplied .
4)The Display value indicate corresponds to the range
selected. If the Display shows " 1 ", it indicates an out
of range selected measurement, then select the next
higher range.
Note :
In order to make precision measurement at lower
range, to deduct the stray resistance of measuring leads
from the readings. The stray resistance can be
measured by shorting the leads.
7. DIODE MEASUREMENT
PROCEDURE
1)Slide the " LC/R select switch " ( 3-3, Fig. 1 ) to the " R "
position.
2)Rotate the function switch to the " Diode " range.
3)Connect Red alligator to " + " socket of " Diode
Measuring terminal " ( 3-7, Fig. 1 ).
4)Connect Black alligator to " - " socket of " Diode
Measuring terminal " ( 3-7, Fig. 1 ).
9