13.
CARE & MAINTENANCE
12.
TROUBLESHOOTING
♦ If the monitor doesn’t turn on when power is applied:
1.
Check to make sure the power source is active (if your cigarette lighter is
switched with vehicle ignition, your monitor will only work when the vehicle
is running or the key in the ON position).
2.
Check to make sure the fuse and power cord are in working order.
1. T
he battery in the camera may be depleted and require recharging.
♦ If the monitor doesn’t display images within a few
seconds of touching the starting button:
2.
In the process of use, there is wireless interference from outside. so if you
can't turn on the product over 15 seconds after touching the botton , please
touch the Touch for Rearviw botton again to turn it on
.
Check that the camera lens is clean from road grime, snow, or ice.
♦ If the video image is poor:
Recharge the battery in the camera.
♦ If the video image does not last 30 seconds:
Don’t clean or wipe the All-in-one Camera with solvents or
chemical materials. If necessary, remove dirt or stains using
a soft cloth dampened with a mild detergent solution.
Cleaning
Fuse Replacement
1. Turn the cap on the tip of the power plug counterclockwise
(no tools needed).
2. Remove the cap, center pin and fuse.
3. Replace the fuse with a new 1-am fuse.
4. Replace the center pin and cap. Turn the cap clockwise.
The Wireless SolarPower RearVision is designed to provide years
of service. The RearVision WSU43 should be recycled or safely
disposed of at a local recycling center.
Disposal
14
♦ If no image after touching “Touch for Rearview”Botton
in quiet (no vibration at all) environment, such as testing
the WSU43 in office or laboratory.
Vibrate the camera, touch the powered Monitor “Touch for Rearview” button
quickly (not over 3 minutes from vibration) to wake up the sleeping camera,
make it enter standby status and receive the command from the monitor.
Notice:
Under the actual situation of installation, test, and use of vehicle, the
environment is different totally. Little vibration must happen when open
vehicle door, people touching the vehicle, even the engine work.
So the camera will stay at standby status
.
*
13
