SUNWARD SWE50B, Operation & Maintenance Manual

Page: 104 / 197

97
cleaned in time.

Open right side door of machine hood
；

Loosen the mounting bots located on left side of condenser,
open up condenser of A/C.

Use compressed air (below 0.2 MPa) or water to rinse
condenser.

Remove the strainer (if present) in front of radiator for
cleaning up.

Use compressed air (below 0.2 MPa) or water to rinse
cooler.

Reinstall the front strainer (if provided) and condenser of
A/C.
Note: Do not remove air conditioning piping, failure to do
so will cause coolant leakage and lead to air conditioning
malfunction.
5.5.3.3 Checking and Fastening Track Bolt
If operating machine with bolts loosened, there is hazard that the
bolts will rupture. Therefore the loosened bolts should be
fastened.
Tightening method

Track shoe
1) Tighten at torque 490 ± 49 N m (50 ± 5 kgf m, 360 ± 36
lbft), then check to make sure that nuts contact with track
link surfaces securely.
2) After checking, retighten 120° ± 10°.

Rubber block ( if mounted)
1) Tighten at torque: 549 ± 59 N m (56 ± 6 kgf m, 405 ± 43
lbft).
2) After tightening, check to ensure that nut and track link
contact surface contact against each other securely. .
Tighten Sequence

Tighten bolts in the sequence given in right fig.

With bolts tightened, check bolts and track link mating face
to ensure they contact securely.